Components Tab

The Components tab fields allows you to document the structure's frame, grade adjustment information, cone details, wall material, dimensions, step condition, structure depth, and other attributes. These fields are described in the table below:

Field Name

Use/Purpose

Frame Offset (in)

This refers to any misalignment (offset) the frame has with the grade adjustment, top of the cone, or flat-top section of the frame. Record the distance (in whole inches).

Riser Height (in)

A riser is a circular metal extension that fits into the top of the frame and raises the cover a short distance (typically two or three inches). It is sometimes held in place by set screws. Record the distance in inches from the bottom edge of the lowest riser to the bearing surface or seat upon which the cover rests.

Grade Adjustment

The grade adjustment type is the vertical portion of the manhole between the bottom of the frame and the top of the cone or flat top.

Grade Adjustment Depth (in)

 

The grade adjustments (in inches) are measured from the bottom of the frame to the top of the cone or flat top. If none exists or it cannot be determined where the adjustments begin or end, enter '0' (zero).

Grade Adj Min Dia (in)

The minimum clear opening within the grade adjustment (in inches).

Cone/Top

Cone/Top Shape

The material used in construction and shape of the cone or flat top observed.

Wall Material

Liner

The type of wall material and lining used in the structure.

Dia/Length (in)

The minimum diameter encountered below the cone and above the bench. In this field, record (in inches) the diameter immediately above the wall-to-bench joint. When the cone extends completely down to the bench, record the diameter at the cone and bench joint. If the manhole is not round, indicate the length of the manhole (in inches).

Width (in)

If the structure is not circular, then you can use the width field to designate the shorter length.

Bench

Trough

Pipe Seal

Steps

Use these code-description pick lists to indicate the type of bench, trough, pipe seal, and steps present.

Note: For the Trough, indicate "1 - None" if no trough exists and the water pools before exiting the manhole. For the Bench and Trough, indicate "2 - Precast" only if it is very apparent that the bench and invert were formed and poured as part of the manhole manufacturing process.

Steps Condition

Use this pick list to indicate the condition of the manhole steps as observed.

Structure Depth (ft)

The distance (in feet) from the center of the trough to the center of the frame opening.

Surcharge Evid (ft)

This refers to evidence of solids, papers, debris, or grease deposits on the sides of the manhole, indicating that sewage has risen above the crown of the outgoing pipe. If evidence is present, indicate the distance (in feet) from the center of the trough to the debris line. If no evidence is present, indicate '0' for None.

See Also

Structure Inspections

Sewer Structure Inspection Header Data

General Tab

Defects Tab

Defect Summary Tab

Custom and Comments