Meters Tab

This tab contains two grids: Potable Water and Recycled Water. Both grids allow you to associate one or more existing meters with your Water Site. To add meters to either grid, follow the steps below:

  1. Right-click in a grid and select Add Record. A window similar to the following will appear:

    Potable Meter Loc

  2. Click on the Meter Location No button to access the pick list.
  3. Highlight a meter in the list and click Select.

    Meter Loc

    Note: Each meter location can only be connected to a single Water Site record. If the meter location you select is already connected to a Water Site, you'll receive the following message:

    Water Site Prompt

  4. Save and Close the record. The meter you selected will be added to the appropriate grid.

    Note: In order for the meter locations to appear in the grids, you must have installed meter devices in the Water Distribution Meter Location module (for the Potable Water grid) and Recycled Water Meter Location module (for the Recycled Water grid). If the record you added does not appear in the grids, it may be because that location does not have a device installed. For additional information on installing devices in the meter locations, click on the links above.

  5. You can then use the functions in the grids to View, Edit, or Delete meters.

See Also

Water Sites

Water Sites Header Data

Address Tab

Supervisor Tab

Owner Tab

Violation Tab

Construction Tab

WO/PM

Custom and Comments

Toolkit