Information Once Selected

Field Name

Function

Rehabilitation Cost

Patching Cost

These fields are user-defined.  Here, you can indicate the per area costs for rehabilitation and patching when using this rehab technique. The values in these fields will be used in the model runs for budget forecasting.

Note: The Patching Cost is based on the estimates in the latest Field Inspection module.

Reset PCI Value

After rehabilitation is complete using this technique, the street PCI will be reset to the value in this field.  For further information on PCI, see the Field Inspections help guide.

Restoration Points

This is the number of PCI points that a selected supersegment's PCI will be raised if this rehab method is selected. This is not a required field but will override the Reset PCI Value if one exists.

Minimum Life

This field allows you to establish a minimum life span for the rehab technique. If entered, the minimum life field will update the model so that once a rehabilitation activity is selected, the supersegment cannot be selected again until after the specified number of years has been completed.

Rehab Group

You can enter a numerical value in this field to track the rehabilitation group. A rehab group can be set for similar rehab techniques.

Note: If you want to use the Rehab Group for a model run (or in the Budget module), this group number must be included in the Rehab per Pavement/Classification module.

Curb Replace

Sidewalk Replace

Driveway Replace

These fields are used to indicate whether the curbs, sidewalks, and driveways are to be partially replaced, fully replaced, or not replaced when using this rehab technique.  The data in these fields will be used in the model runs. You have three options when entering data in these fields:

• No Replacement - No miscellaneous cost for this rehabilitation type will be used.
• Replace Est Only - The miscellaneous cost for this rehabilitation type will equal the supersegment Replacement Est * Misc Cost for the feature.
• Total Replacement - The miscellaneous cost for this rehabilitation type will equal the total length * Misc Cost for the feature.

Reset Load Factor

Reset Non-Load Factor

Reset Environmental Factor

Reset Structural Factor

Reset Roughness Factor

These fields can be used to reset the various factors once rehabilitation is complete.  The factors will be reset to the values included in these fields.  For further information on factors, see the Field Inspections help guide.

Note: These fields are only helpful if you are using Factors to determine maintenance activities.