Use Pipe Section Length when Available for Continuous Defect Calculation

If this option is set to "Yes", the system will use the length from Conduit Inventory to calculate the conduit conditions where a continuous defect was noted.

Note: This option supersedes the value in the “Default Length” option.

To enable this option, complete the following steps:

1. Click to enter Edit Mode.
2. Highlight Use Pipe Section Length when Available for Continuous Defect Calculation.
3. Right-click on the option and select "Edit".
4. Change the value to "Yes" or "No" using the drop-down menu.
5. Click .